The Most Common Washing Machine Problems and How to Fix Them

washing-machine

If you are looking for ways to repair washing machine problems, remember that not all problems are fixable. Sometimes, it will be hard even to detect what’s wrong with the appliance. And you should always keep in mind that not all models have the same specs and thus the same solutions. All washers might leak but the way you fix each appliance might differ. So, this might be a guide of how to detect problems and fix your washer, but it’s often best to find a local washing machine technician to tackle issues.

The washing machine won’t start

The first thing to check is the electrical outlet. If there is no power, the appliance won’t start. If you plug something else in and it works, there might a problem with the power cord. If there is no power, check the fuses. This problem is also caused when the display board and user control are defective. If by pressing the control panel some buttons don’t work, replace these parts.

The washer won’t spin

The motor coupling, which connects the appliance’s transmission to the motor, won’twashing machine repair work due to damage or when the washer is overloaded. This problem can also happen when the drive belt is broken or when the lid is open. But the pulleys which enable the drum to spin might also break, the door latch might be damaged, the clutch connecting the tub to the transmission might be broken, and the motor control board might be defective. Defective parts must be replaced.

 

The washing machine won’t drain

Two common reasons why washers won’t drain is kinked hoses and small articles (like socks) getting into the drain system. One of the main washer repair tasks is to check the pump and remove anything blocking the system. But if the lid switch assembly is damaged, the washer won’t drain either.

The washer is leaking

This is one of the most urgent washing machine repairs. When the drain pump, tubAppliance Repair seal, hoses, or door boot seal is broken, the appliance leaks water. The best way to avoid such emergencies is to maintain the washer and make sure the door is shut air tight.

The washing machine fills slowly

This problem often occurs when the water inlet valve is worn. This valve opens to let water in. But it will also work right when it receives the right amount of water. So check for adequate amount of water coming in. On top of that, check water pressure and make sure all hoses are alright.

The washer won’t agitate

Naturally, if the agitator is defective, it must be replaced. But sometimes, the washer won’t agitate when the drive block connecting the agitator to the transmission is worn or the motor coupling is damaged. The problem might also be caused when the drive belt or pulleys are broken or there is an issue with the motor control board.

Remember that problems always have an explanation but more often than not they have more than one reasons for the appliance to act up. And that’s why you will need the assistance of a specialized appliance service technician.